After updating to 0.108.2 it throws the following error. Same here, also for a serial modbus setup, still working perfect on 0.107.7. Wired correctly, changed baud rate for comms to 9600 and used the following config and I have some nice looking gauges now using this very cost-effective MODBUS RTU > MODBUS TCP gateway! I found a blog post that indicated the A and B terminals on my SDM220 may be printed backwards so I re-wired it (incorrectly) as I failed to note the blog post was 2015!! 12:52:41 INFO (MainThread) Setup of domain sensor took 6.4 seconds. 12:52:41 INFO (MainThread) Bus:Handling > 12:52:41 INFO (MainThread) Setting up sensor.modbus This is the output of the home assistant logs: 12:52:41 INFO (MainThread) Bus:Handling In the configuration.yaml file I’ve the following: modbus: Hello, I’m trying to read the values of this power meter, but they always show the value of 0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |